| Waveforms are DC-coupled (components connected directly together without any coupling capacitors), so they keep their shape even at sub-Hz speeds. The outputs are also buffered, so the amplitude is independent of the load they are driving. The waveform levels on some modern eurorack OSCs are often all different, and they vary depending if they go into the mixer or directly to the filter!. Coupling the circuitry without capacitors in-line gives the go-ahead for the full spectrum of frequencies to do their thing, and ensures near identical response over the yearsaudiophile, transistor-protecting signal path stuff here. You should see these beauts on the scope: a Class-A ballet of balance and proportion, only drawing modest current, evenly from plus and minus.
> tech specs
Three attenuation, and three attenuverter pots control the FREQUENCY, TUNE, PW CV IN, PUSLE WIDTH, FM CV IN, and SUB LEVEL, delivering smooth, detailed, and complex expression.
Switch it Up
NORMAL and LOW RANGE - wide sweeping audio frequencies, or clicks (respectively) for creating a rhythmic pulse or sweep; SINE, TRI, SAW, SQR - your friendly waveform on and offs.
Patch it Up
Eleven patch points: 1 V/O, FM IN, WAVE MIX, SYNC IN, PW IN, SUB OUT, SINE OUT, TRI OUT, SAW OUT, RAMP OUT, SQR OUT direct the deepest manipulation.
All Controls and Patch Points
FREQUENCY Oscillator frequency attenuator.
NORMAL / LOW RANGE Oscillator domain switch.
TUNE Oscillator fine-tune attenuverter.
PULSE WIDTH Variable pulse wave width control.
SINE Sine wave on/off.
TRI Triangle wave on/off.
SAW Sawtooth wave on/off.
SQR Square (pulse) wave on/off.
FM CV IN Frequency Modulation control voltage input attenuverter.
SUB LEVEL Sub (one octave down) level attenuator.
1 V/O One volt per octave control voltage input.
FM IN Frequency Modulation control voltage input.
SYNC IN Oscillator Sync control voltage input.
PW IN Pulse Width control voltage input.
SUB OUT Sub Oscillator output.
SINE OUT Sine Oscillator output.
TRI OUT Triangle wave output.
SAW OUT Sawtooth wave output.
RAMP OUT Ramp (reverse sawtooth) wave output.
SQR OUT Square wave output
Size - 16hp
Depth - 39.7mm with ribbon cable attached
Power Usage - 44mA, 39mA (+12 / -12)