| This product is available only on order.
Each sequence is controlled by a column of three knobs and a switch.
The input parameters to the algorithm are sequence length and fills.
The length of the sequence, measured in clocks or beats, is controlled
by the second knob from the top. The range goes from 1 (fully counter
clockwise) to 16 (fully clockwise), with 8 in the centre position.
The number of fills, or on-beats, is set by the third knob. In fully
counter-clockwise position, this is set to 1. Centre position will set
every other beat ‘on’, or 50% . Fully clockwise sets every beat ‘on’,
in other words: the number of fills are equal to the sequence length.
The top knob adjusts which beat the sequence starts on – and hence
resets to. In its centre position, the sequence will start on its first
step. The start position can be changed by turning the top knob left or
right: this will have the effect of rotating the sequence left or
> tech specs
Height: 3U / 128.50mm
Width: 10HP / 50.50mm
PTC fuse and diode protected
+12v: < 10mA
+5v: < 25mA
Outputs: < 1.1k
Inputs: > 100k
Output low: 0v
Output high: 5.1v